Surface features to paper
The base should be clean and smooth and must be absorbent. Do not ever about old papers paper.
Surface preparation to paper
In case you are papered, water softener use of paper (020, COLOWALL LEIZ0L) to wet the surface, soften and remove the paper. For papers very strong, piercing it with a barrel of nails, so you can penetrate the water, let stand for wet and then remove the paper.
Align the paper at the corners
Normally the corner is not perfectly vertical, so it is advisable to draw a reference mark to place the first strip of each wall, for example, draw a line using a spirit level or plumb.
How to proceed with plugs and switches
Coat it with the paper after removing the protections and make a cross cut, clean the glue stuck and when the paper has dried, cut the plugs covering the cutter.
How to proceed with the doors
Always start papering one side, cut the wallpaper to fit the frame. Cut a piece to the top of the door in response to match the fitting. Then place the next full strip on the door with a small surplus in length and cut to fit the frame with a cutter.
Wallpapering always starting with one side but without adjusting the strip to the edge of the hole in the window, but protruding and cover the depth of the niche and then some.
Cut the excess at the top and bottom, fold the paper back into the hole and cut to fit the edge of the window. Cut the piece above the window, leaving a surplus. At the top of the window, a piece cut to size strip of sufficient length to cover the depth of niche, taking place on the window to the fitting of the paper so that it covers the ledge. Use a knife to cut both vertical edges of the strip so that it ends exactly at the corner of the niche. After removing the trim beneath the binding, cut the strip to an approximate length, leaving a surplus, fold inward into the hole, press and cut to fit the window with a cutter. Apply the other strips in response to match the fitting.
Cleanly cut the notches for the belt of the blind so that cutting edges are covered later by the bezel.
Problems may occur in the transition to the vertical walls. If molding is uniform can paste a full strip covering from the top to the corner. Cut the strip at that point and go down with a new strip. Place the top strip on the bottom, overlapping it. If the molding is not straight, cut the upper and lower strips separately by adding a surplus. Once attached the upper strip and paste the below response to match the subject and to ensure it reaches to below the top strip.
First insert strips located next to and above the arch, leaving a surplus of 2 or 3 cm. Make several cuts in the long outstanding two different fragments and glue the bow. Next, cut the soffit strip cut to size. To get clean joints, especially with patterned paper, ribbons used for the corners outlined previously adapted to each arc.
Thus, the separation between the soffit and wall patterns that (necessarily) can not match, it will be aesthetically correct.
Cut the paper to the extent appropriate and adapt to the area of the tube by folding in a star. Press and cut with a cutter around the pipe.
The ideal temperature is 18 ° C, free from drafts or excessive heat. Avoid rapid drying by increasing tensions in the role, reaching to open the joints.